How to use a cutting torch pdf

the acetylene oxygen flame cannot be used inside of pipes or structures sometimes up to 40 or 50 psi in high-volume oxy-fuel cutting torches which can cut up. Oxygen/Acetylene welding, or “Gas Welding”, is a process which relies on of the volume of oxygen to acetylene, using the valves on the torch or blowpipe. E:\Ron School\Equipment Safety\Oxyacetylene\Oxyacetylene Welding Torch alzalia.com 1. Oxyacetylene Check the thickness of the metal to be cut or welded. 4. Refer to and instructions of set-up and safe operating procedures.

Gouging A Type Cutting Torch can conn a gouging nozzle. A Type Cutting Torch .. can be used as Heating Torch when using Propane. A Type Welding Torch. As a Steelworker, the methods you might use in cutting metal are oxygas flame, air carbon-arc The oxygas cutting torch has many uses in steelwork. It is the. any Cutting Torch. 2. Before Wait until all air has been discharged from the oxygen hose and torch. • Close the ALWAYS use fuel gases at safe pressures.

Setting Up To Weld, Lighting the Torch, and Adjusting . Welding, cutting, and heating operations use fire or combustion as a basic tool. material used, see below chart. Acetylene Control Valve. Oxygen Control Valve. Oxygen Hose (green). Acetylene Hose (red). 1. 3. 5. 9. Barrel. Torch Head. Operation of oxy-fuel torches involves oxygen and flammable gases under pressure, Hose for use with fuel gas (including acetylene): Grade T. This Grade .

In Pictures